Whole-home duct cleaning
Dryer vent cleaning
Camera inspection
Sanitizing & deodorizingWhole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Rotobrush Vent Sanitizing: The Orange County Owner’s Guide
We stock and install Rotobrush-compatible vent sanitizing components across Orange County, with most replacements running $145 – $285 installed depending on your Rotobrush model and what actually failed. Most jobs are completed the same day we diagnose the issue, since our trucks carry the common Rotobrush sanitizer parts that wear out first. Homeowners typically discover the problem mid-job: the sanitizer stops misting evenly, the pump hums but nothing sprays, or the wand drips instead of atomizing. Sometimes it’s a slow failure you notice over a few jobs, like weaker coverage or a sanitizer smell that fades too fast after application.

If you’re reading this, you probably already know the frustration: a machine that worked fine last season, now acting up when you’re halfway through a vent run. Paul Adeyemi has seen this pattern plenty of times in homes around Orange County, from Irvine townhouses to Anaheim Hills properties with long duct runs that put real demand on the sanitizing system. The good news is that Rotobrush sanitizing components are straightforward to diagnose once you know what to look for.
Key takeaways:
- We carry Rotobrush-compatible sanitizer pumps, hoses, nozzles, and wand assemblies on our trucks
- Installed pricing runs $145 – $285 for most Orange County homes
- We’re an independent service provider, not affiliated with Rotobrush, but we’ve worked on their equipment for years
- Diagnosis is free with any cleaning or service call
Which Rotobrush Models This Applies To
Rotobrush vent sanitizing has shipped under a few different configurations over the years, and the parts are not universally interchangeable between them. The most common units we see in Orange County are the aiR+ and the older AirCobra series, along with standalone sanitizer pumps paired with rotating brush systems from the same era. The identifying label is usually on the back of the sanitizer housing near the power input, and the model matters because the pump fittings changed between generations. An aiR+ sanitizer pump will not simply thread onto an AirCobra-era reservoir without an adapter, and the pressure ratings differ enough that mixing them creates a weak mist or a leak at the fitting.
For OEM parts versus aftermarket, our honest take after years of installing both: the Rotobrush OEM sanitizer pump is well-built and worth the premium if your unit is still under any coverage or if you plan to keep the machine for another five years. But there are quality aftermarket pumps that match the OEM pressure curve closely, and for an older unit that is mostly doing residential jobs, we’ve seen aftermarket options perform fine. We’ll show you both prices and tell you what makes sense for how much you actually use the machine. We keep both on the truck for the common units.
We also work on sanitizing setups using components from Lennox, Trane, and Carrier systems, though those are less common for this specific attachment.
Styles & brands we work with




Signs Your Rotobrush Vent Sanitizing Is Failing
- Weak or uneven mist from the wand. This almost always points to a worn pump diaphragm or a partially clogged nozzle. The pump still runs, but it can’t maintain the pressure needed to atomize the sanitizer properly. You’ll see drips instead of a fine mist.
- Pump runs but no liquid moves. Usually a failed check valve or a cracked pickup tube inside the reservoir. The check valve is a small, inexpensive part that fails from sanitizer residue and should be the first thing we test.
- Sanitizer leaking from the wand handle or hose connection. The O-rings at these fittings dry out and shrink in Orange County’s low-humidity seasons. It’s a cheap fix, and we replace all of them together so you don’t chase leaks one at a time.
- Unit trips a breaker or shuts off mid-job. This is a different failure and more serious. It usually means the pump motor is drawing too much current, and that’s the point where you stop using it until it is checked. A seized pump can damage the control board on some models.
- Sanitizer odor is weak or gone immediately after cleaning. If the machine is misting but the smell disappears fast, it may not be failing mechanically. It could be under-dosing because of a worn pump or an incorrect dilution. We check the output volume against the spec before assuming.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
For Orange County homes, Rotobrush vent sanitizing component replacement runs $145 – $285 installed, including the part and our labor. The range depends on which part failed and which Rotobrush series you own. A new set of O-rings and a check valve might sit at the low end. A full pump replacement on an aiR+ unit typically lands around $220 – $285 installed.
You will know the exact price before we open the panel. That’s how Paul runs every job, and it’s how we’ve run Morton’s Air Duct Orange County since day one: a written quote first, no surprises on the invoice. We tell you the price before we open the panel, every time. Every replacement is covered by our 365-Day Done Right Promise, and we stand behind the parts we install with the manufacturer’s warranty plus our own workmanship guarantee. If the same part fails within the year, we return and make it right.
DIY or Call Us?
A few things on a Rotobrush sanitizing unit are genuinely simple for an owner to handle. Replacing a cracked pickup tube or clearing a clogged nozzle is within reach if you’re comfortable with basic tools, and we’ll happily point out which end is which over the phone. But anything involving the pump itself, the wiring, or the control board is not a safe DIY project. These units combine electrical current with liquid, and a partial repair that leaves a compromised seal can spray sanitizer where it was not meant to go, including onto wiring. That’s not a risk worth taking.
What we see happen is an owner replaces a $15 nozzle when the real issue is a $90 pump, then ends up paying for both anyway. If you are not sure, call us at (831) 244-9367. We’ll help you diagnose it over the phone, and if it’s a simple fix we’ll tell you exactly how to do it yourself and what part to buy. If it’s not simple, we’ll bring the right part to your door in Orange County and have you running again the same day.
FAQs
Most Rotobrush sanitizer pumps last 3 to 5 years with regular residential use in Orange County, though homes with long duct runs or frequent cleaning schedules will wear one out faster. The pump diaphragm is the first component to go, and it degrades faster in dry inland climates like Anaheim or Yorba Linda than in coastal areas like Newport Beach. If your unit is approaching that age and acting erratic, the pump is the first place we look.
Some components, like check valves and O-rings, are routinely repaired as standalone parts. But the pump itself is usually replaced as a unit because the diaphragm, motor, and pressure switch are not sold separately by Rotobrush for most of the units we see in Orange County. Rebuilding one is possible in theory but rarely cost-effective compared to a quality replacement pump. We will always tell you which path is cheaper before we do anything.
Most jobs take 30 to 45 minutes from the time we arrive to the time we’re packing up. A pump replacement on a Rotobrush aiR+ unit runs closer to an hour because the unit typically needs a fitting change and a pressure test. You’re back to cleaning that same afternoon.
Yes. Our trucks carry the common Rotobrush sanitizer components we replace most often: pumps, check valves, O-ring kits, pickup tubes, nozzles, and wand fittings. If you have an uncommon configuration, we can typically have the exact part within a day or two from our local supplier. Call (831) 244-9367 and we’ll check the truck before we head your way.
Written by Paul Adeyemi, Owner, Mortons Air Duct Orange County at Mortons Air Duct Orange County, serving Orange County and nearby areas.